PAYLOAD REMOVAL PROCEDURE
(please select the step to view)
1.
Open Rover aft port
2.
Power shutdown ANSB Payload
√ Line 1 reads “SYSTEM DISPLAY”
pb 1 (NEXT) → press 6 times
√ Line 3 reads “WARM SHUTDOWN”
pb 2 (APPLY) → press
pb 1 (APPLY) → press
√ Line 1 reads “SHUTDOWN DONE”
cb MAIN → Open
√ cb PAYLOAD → Open
3.
Disconnect power cable on front of ANSB Payload Power Cable 24" ←| → POWER - J1
4.
Unfasten payload from Rover (4 fasteners) & remove ANSB Payload
5.
Disconnect power cable at back connection point within Rover
Power Cable 24" ←| → Back Power Port
6.
Replace with new power cable, connect first in the Rover
Power Cable 24" →| ← Locker-4 Power-J1
7.
Reinsert ANSB Payload into Rover & secure with 4 fasteners
8.
Unlock & open the ANSB Payload
9.
Remove Sample Collection Plate
10.
Insert Unexposed Sample Collection Plate
11.
Close & secure door to ANSB Payload
12.
Connect new power cable to front of the ANSB Payload Power Cable 24" →| ← POWER - J1
13.
Power up ANSB Payload
cb MAIN → Open
14.
Close Rover aft port
